-enable hs533 mode.
-set max clock limit to 266MHz.
-Set clock parent as pll_c4_out1.
Change-Id: Ibe77163f07a23ea21a9d11085f85429d07ec39d7
Signed-off-by: Naveen Kumar Arepalli <naveenk@nvidia.com>
Reviewed-on: http://git-master/r/601058
Reviewed-by: Automatic_Commit_Validation_User
Reviewed-by: Venu Byravarasu <vbyravarasu@nvidia.com>
- nvidia,is-emmc: Enable this flag for eMMC devices
- nvidia,enable-ext-loopback: flag when set, enables external loopback
- nvidia,limit-vddio-max-volt: enable this flag for sdmmc1/3 if it has Vddio 3.3v support.
+- nvidia,enable-hs533-mode: Set this Flag toenable HS533 mode.
+ ---> eMMC card does not advertise HS533 mode support in device registers.
+ ---> This flag has to be enabled only if the card supports HS533 mode, other wise the consequences are un-known.(Errors will be seen)
Example:
nvidia,ddr-tap-delay = <0>;
mmc-ocr-mask = <0>;
dqs-trim-delay = <17>;
- max-clk-limit = <200000000>;
+ max-clk-limit = <266000000>;
bus-width = <8>;
calib-3v3-offsets = <0x0505>;
calib-1v8-offsets = <0x0505>;
compad-vref-1v8 = <0x7>;
nvidia,en-io-trim-volt;
nvidia,is-emmc;
+ nvidia,enable-hs533-mode;
+ pll_source = "pll_p", "pll_c4_out1";
};
sdhci@700b0400 { /* SDMMC3 for 2nd Wifi on loki */
};
sdhci@700b0600 {
- uhs-mask = <0x60>;
+ uhs-mask = <0x0>;
built-in;
power-off-rail;
status = "okay";