doc: Fix information about OpenOCD state

diff --git a/doc/rpp_simulink.tex b/doc/rpp_simulink.tex
index 0aed699da15a40d9b40dbffaaae8462858680a66..9c32c8ebb58f6646c55a3d3bea7ebe65e0fee1d3 100644 (file)
--- a/doc/rpp_simulink.tex
+++ b/doc/rpp_simulink.tex
@@ -1311,19 +1311,19 @@ ends with a success, the download process will start and once the downloading is
 finished, the application will run immediatelly.
 \end{enumerate}
 
-\subsubsection{Using OpenOCD for downloading}
-\label{sec:using-open-downl}
-
-On Linux systems, it is possible to use an alternative download
-mechanism based on the OpenOCD tool. This results in much shorter
-download times. Using OpenOCD is enabled by checking ``Use OpenOCD to
-download the compiled binary'' checkbox. For more information about
-the OpenOCD configuration refer to our
-wiki\footnote{\url{http://rtime.felk.cvut.cz/hw/index.php/TMS570LS3137\#OpenOCD_setup_and_Flashing}}.
-
-Note: You should close any ongoing Code Composer Studio debug sessions
-before downloading the generated code to the RPP board. Otherwise the
-download fails.
+%%\subsubsection{Using OpenOCD for downloading}
+%%\label{sec:using-open-downl}
+%%
+%%On Linux systems, it is possible to use an alternative download
+%%mechanism based on the OpenOCD tool. This results in much shorter
+%%download times. Using OpenOCD is enabled by checking ``Use OpenOCD to
+%%download the compiled binary'' checkbox. For more information about
+%%the OpenOCD configuration refer to our
+%%wiki\footnote{\url{http://rtime.felk.cvut.cz/hw/index.php/TMS570LS3137\#OpenOCD_setup_and_Flashing}}.
+%%
+%%Note: You should close any ongoing Code Composer Studio debug sessions
+%%before downloading the generated code to the RPP board. Otherwise the
+%%download fails.
 
 \section{Configuring serial interface}
 \label{sec-configuration-serial-interface}
@@ -1688,16 +1688,8 @@ the loaded program a manual reset of the board is required.
 \item \textbf{Download compiled binary to SDRAM}: This feature is not yet
 implemented for the simulink target.
 
-\item \textbf{Use OpenOCD to download the compiled binary}: This option switches
-from Ti loading script \texttt{loadti.sh} to OpenOCD script
-\texttt{loadopenocd.sh}. The benefit of using OpenOCD, besides that it is open
-source
-  software, is much shorter loading time. More information about the right
-OpenOCD version and its installation can be found at:
-\begin{verbatim}
-http://rtime.felk.cvut.cz/hw/index.php/TMS570LS3137#OpenOCD_setup_and_Flashing
-\end{verbatim}
-This feature is available for Linux system only.
+\item \textbf{Use OpenOCD to download the compiled binary}: This feature is not yet
+implemented for the RM48L952 simulink target.
 
 \item \textbf{Print model metadata to SCI at start}: if set this option will
 print a message to the Serial Communication Interface when the model start