ARM: tegra: move pinmux dt node before gpio mode

Move the pimx DT node before gpio node to make sure that
pinmux get registered before the gpio.

Change-Id: I55d5a5c1a1570c16d8332ba224e0ed9a1f7c257c
Signed-off-by: Laxman Dewangan <ldewangan@nvidia.com>
Reviewed-on: http://git-master/r/412630
GVS: Gerrit_Virtual_Submit

diff --git a/arch/arm/boot/dts/tegra124-soc.dtsi b/arch/arm/boot/dts/tegra124-soc.dtsi
index 55abee8d6032d03b6a29249c5c3364a102f31f79..85cbfee37cc1e1c8d12df9ed027b26abb0990e29 100644 (file)
--- a/arch/arm/boot/dts/tegra124-soc.dtsi
+++ b/arch/arm/boot/dts/tegra124-soc.dtsi
@@ -39,6 +39,12 @@
                channels = <1>;
        };
 
+       pinmux: pinmux {
+               compatible = "nvidia,tegra124-pinmux";
+               reg = <0x0 0x70000868 0x0 0x164         /* Pad control registers */
+                      0x0 0x70003000 0x0 0x434>;       /* Mux registers */
+       };
+
        gpio: gpio@6000d000 {
                compatible = "nvidia,tegra124-gpio", "nvidia,tegra30-gpio";
                reg = <0x0 0x6000d000 0x0 0x1000>;
@@ -107,12 +113,6 @@
                #dma-cells = <1>;
        };
 
-       pinmux: pinmux {
-               compatible = "nvidia,tegra124-pinmux";
-               reg = <0x0 0x70000868 0x0 0x164         /* Pad control registers */
-                      0x0 0x70003000 0x0 0x434>;       /* Mux registers */
-       };
-
        /*
         * There are two serial driver i.e. 8250 based simple serial
         * driver and APB DMA based serial driver for higher baudrate