+ /* Program the fixed DMA controller parameters */
+
+ dma_channel = dma_private->dma_channel;
+
+ temp_link = dma_private->ld_buf_phys +
+ sizeof(struct fsl_dma_link_descriptor);
+
+ for (i = 0; i < NUM_DMA_LINKS; i++) {
+ struct fsl_dma_link_descriptor *link = &dma_private->link[i];
+
+ link->source_attr = cpu_to_be32(CCSR_DMA_ATR_SNOOP);
+ link->dest_attr = cpu_to_be32(CCSR_DMA_ATR_SNOOP);
+ link->next = cpu_to_be64(temp_link);
+
+ temp_link += sizeof(struct fsl_dma_link_descriptor);
+ }
+ /* The last link descriptor points to the first */
+ dma_private->link[i - 1].next = cpu_to_be64(dma_private->ld_buf_phys);
+
+ /* Tell the DMA controller where the first link descriptor is */
+ out_be32(&dma_channel->clndar,
+ CCSR_DMA_CLNDAR_ADDR(dma_private->ld_buf_phys));
+ out_be32(&dma_channel->eclndar,
+ CCSR_DMA_ECLNDAR_ADDR(dma_private->ld_buf_phys));
+
+ /* The manual says the BCR must be clear before enabling EMP */
+ out_be32(&dma_channel->bcr, 0);
+
+ /*
+ * Program the mode register for interrupts, external master control,
+ * and source/destination hold. Also clear the Channel Abort bit.
+ */
+ mr = in_be32(&dma_channel->mr) &
+ ~(CCSR_DMA_MR_CA | CCSR_DMA_MR_DAHE | CCSR_DMA_MR_SAHE);
+
+ /*
+ * We want External Master Start and External Master Pause enabled,
+ * because the SSI is controlling the DMA controller. We want the DMA
+ * controller to be set up in advance, and then we signal only the SSI
+ * to start transferring.
+ *
+ * We want End-Of-Segment Interrupts enabled, because this will generate
+ * an interrupt at the end of each segment (each link descriptor
+ * represents one segment). Each DMA segment is the same thing as an
+ * ALSA period, so this is how we get an interrupt at the end of every
+ * period.
+ *
+ * We want Error Interrupt enabled, so that we can get an error if
+ * the DMA controller is mis-programmed somehow.
+ */
+ mr |= CCSR_DMA_MR_EOSIE | CCSR_DMA_MR_EIE | CCSR_DMA_MR_EMP_EN |
+ CCSR_DMA_MR_EMS_EN;
+
+ /* For playback, we want the destination address to be held. For
+ capture, set the source address to be held. */
+ mr |= (substream->stream == SNDRV_PCM_STREAM_PLAYBACK) ?
+ CCSR_DMA_MR_DAHE : CCSR_DMA_MR_SAHE;
+
+ out_be32(&dma_channel->mr, mr);
+