ARM: OMAP2: UART: fix console UART mismatched runtime PM status

The runtime PM framework assumes that the hardware state of devices
when initialized is disabled.  For all omap_devices, we idle/disable
device by default.  However, the console uart uses a "no idle" option
during omap_device init in order to allow earlyprintk usage to work
seamlessly during boot.

Because the hardware is left partially enabled after init (whatever
the bootloader settings were), the omap_device should later be fully
initialized (including mux) and the runtime PM framework should be
told that the device is active, and not disabled so that the hardware
state is in sync with runtime PM state.

To fix, after the device has been created/registered, call
omap_device_enable() to finialize init and use pm_runtime_set_active()
to tell the runtime PM core the device is enabled.

Tested on 2420/n810, 3530/Overo, 3530/Beagle, 3730/OveroSTORM,
3730/Beagle-xM, 4460/PandaES.

Suggested-by: Russell King <rmk+kernel@arm.linux.org.uk>
Cc: Felipe Balbi <balbi@ti.com>
Cc: Sourav Poddar <sourav.poddar@ti.com>
Signed-off-by: Kevin Hilman <khilman@ti.com>

diff --git a/arch/arm/mach-omap2/serial.c b/arch/arm/mach-omap2/serial.c
index 0405c8190803a34ef666dd197a15f18dccdcad8f..a507cd6cf4f12259ab6a0bbad75fdc2e38bbe3a8 100644 (file)
--- a/arch/arm/mach-omap2/serial.c
+++ b/arch/arm/mach-omap2/serial.c
@@ -329,6 +329,11 @@ void __init omap_serial_init_port(struct omap_board_data *bdata,
 
        oh->mux = omap_hwmod_mux_init(bdata->pads, bdata->pads_cnt);
 
+       if (console_uart_id == bdata->id) {
+               omap_device_enable(pdev);
+               pm_runtime_set_active(&pdev->dev);
+       }
+
        oh->dev_attr = uart;
 
        if (((cpu_is_omap34xx() || cpu_is_omap44xx()) && bdata->pads)