1 * palmas regulator IP block devicetree bindings
4 - compatible : Should be from the list
10 and also the generic series names
12 - interrupt-parent : The parent interrupt controller which is palmas.
13 - interrupts : The interrupt number and the type which can be looked up here:
14 arch/arm/boot/dts/include/dt-bindings/interrupt-controller/irq.h
15 - interrupts-name: The names of the individual interrupts.
18 - ti,ldo6-vibrator : ldo6 is in vibrator mode
21 - regulators : Must contain a sub-node per regulator from the list below.
22 Each sub-node should contain the constraints and initialization
23 information for that regulator. See regulator.txt for a
24 description of standard properties for these sub-nodes.
25 Additional custom properties are listed below.
27 For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP,
28 smps45, smps457, smps7 depending on variant, smps6, smps[8-10],
29 ldo[1-9], ldoln, ldousb.
31 Optional sub-node properties:
32 ti,warm-reset - maintain voltage during warm reset(boolean)
33 ti,roof-floor - control voltage selection by pin(boolean)
34 ti,sleep-mode - mode to adopt in pmic sleep 0 - off, 1 - auto,
35 2 - eco, 3 - forced pwm
36 ti,tstep - slope control 0 - Jump, 1 10mV/us, 2 5mV/us, 3 2.5mV/us
37 ti,smps-range - OTP has the wrong range set for the hardware so override
38 0 - low range, 1 - high range.
42 #include <dt-bindings/interrupt-controller/irq.h>
45 compatible = "ti,twl6035-pmic", "ti,palmas-pmic";
46 interrupt-parent = <&palmas>;
47 interrupts = <14 IRQ_TYPE_NONE>;
48 interrupts-name = "short-irq";
54 regulator-name = "smps12";
55 regulator-min-microvolt = < 600000>;
56 regulator-max-microvolt = <1500000>;
67 regulator-name = "ldo1";
68 regulator-min-microvolt = <2800000>;
69 regulator-max-microvolt = <2800000>;