support. This is the standard library for CAN drivers.
If unsure, say Y.
+config CAN_CALC_BITTIMING
+ tristate "CAN bit-timing calculation"
+ depends on CAN_DEV
+ default Y
+ ---help---
+ If enabled, CAN bit-timing parameters will be calculated for the
+ bit-rate specified via SYSFS file "can_bitrate" when the device
+ gets started. This works fine for the most common CAN controllers
+ with standard bit-rates but may fail for exotic bit-rates or CAN
+ source clock frequencies. Disabling saves some space, but then the
+ bit-timing parameters must be specified directly using the SYSFS
+ files "tq, prop_seg, phase_seg1, phase_seg2 and sjw".
+ If unsure, say Y.
+
config CAN_SJA1000
depends on CAN_DEV
tristate "Philips SJA1000"
This driver will use the new device interface.
+config CAN_SJA1000_PLATFORM
+ depends on CAN_SJA1000
+ tristate "generic Platform Bus based SJA1000 driver"
+ ---help---
+ This driver adds support for the SJA1000 chips connected to
+ the "platform bus" (Linux abstraction for directly to the
+ processor attached devices). Which can be found on various
+ boards from Phytec (http://www.phytec.de) like the PCM027,
+ PCM038.
+
config CAN_EMS_PCI
tristate "EMS CPC-PCI and CPC-PCIe Card"
depends on PCI && CAN_SJA1000
This driver is for the PCAN PCI, the PC-PCI CAN plug-in card (1 or
2 channel) from PEAK Systems (http://www.peak-system.com).
-config CAN_PCM027
- depends on CAN_SJA1000 && MACH_PCM027
- tristate "Phytec pcm027 can driver (SJA1000)"
- help
- This driver adds support for the SJA1000 chip on the PCM027 board
- from Phytec (http://www.phytec.de).
-
config CAN_PIPCAN
depends on CAN_SJA1000
tristate "MPL PIPCAN CAN module driver (SJA1000)"
This driver is for the the PCIcanx and PCIcan cards (1, 2 or
4 channel) from Kvaser (http://www.kvaser.com).
+config CAN_SOFTING
+ tristate "Softing Gmbh CAN generic support"
+ depends on CAN_DEV
+ ---help---
+ generic softing CAN cards
+
+config CAN_SOFTING_CS
+ tristate "Softing CAN pcmcia cards"
+ depends on CAN_SOFTING && PCMCIA
+
config CAN_MSCAN
depends on CAN_DEV && (PPC || M68K || M68KNOMMU)
tristate "Support for a Freescale MSCAN based chips"
This driver can also be built as a module. If so, the module
will be called mpc52xx_can.
+config CAN_MCP251X
+ tristate "Microchip MCP251x SPI CAN controllers"
+ depends on CAN_DEV && SPI
+ ---help---
+ Driver for the Microchip MCP251x SPI CAN controllers.
+
config CAN_DEBUG_DEVICES
bool "CAN devices debugging messages"
depends on CAN