-You need to know the following:
-" RX1 is connected to ground.
-" TX1 is not connected.
-" CLKO is not connected.
-" Setting the OCR register to 0xFA is a good idea.
- This means normal output mode , push-pull and the correct polarity.
-" In the CDR register, you should set CBP to 1.
+You need to know the following:
+" RX1 is connected to ground.
+" TX1 is not connected.
+" CLKO is not connected.
+" Setting the OCR register to 0xFA is a good idea.
+ This means normal output mode , push-pull and the correct polarity.
+" In the CDR register, you should set CBP to 1.