XC2S100-kit: Difference between revisions
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
This page describes "Spartan II Demo Board" DS-KIT-2S100 | This page describes "Spartan II Demo Board" DS-KIT-2S100 | ||
== ISE Design Suite == | |||
Spartan-II families are NOT supported by ISE 11 and higher. I use ISE 10.1 SP3. | |||
ISE 10.1 is only supported on 32-bit Linux systems, but if the check for 64-bit system is removed from setup script (bash), it works even on 64-bit system. On Debian, you need to install ia32-libs package. | |||
== JTAG Cable == | == JTAG Cable == | ||
Revision as of 15:46, 19 December 2010
This page describes "Spartan II Demo Board" DS-KIT-2S100
ISE Design Suite
Spartan-II families are NOT supported by ISE 11 and higher. I use ISE 10.1 SP3.
ISE 10.1 is only supported on 32-bit Linux systems, but if the check for 64-bit system is removed from setup script (bash), it works even on 64-bit system. On Debian, you need to install ia32-libs package.
JTAG Cable
Model: IJC-2
Open-Source driver
http://www.rmdir.de/~michael/xilinx/
git clone git://git.zerfleddert.de/usb-driver
To compile 32-bit version on 64-bit system (Debian Squeeze), I had to change the Makefile according to the following patch:
diff --git a/Makefile b/Makefile index baff08d..f22653c 100644 --- a/Makefile +++ b/Makefile @@ -11,6 +11,7 @@ HEADER=usb-driver.h xpcu.h parport.h jtagkey.h config.h jtagmo ifeq ($(LIBVER),32) CFLAGS += -m32 +LIBS=-ldl /lib32/libusb-0.1.so.4 -lpthread endif FTDI := $(shell libftdi-config --libs 2>/dev/null)
Use LD_PRELOAD variable before starting ISE. I use the following script to start ISE:
#!/bin/bash . /opt/Xilinx/10.1/ISE/settings32.sh export LD_PRELOAD=/home/xxx/src/xilinx/usb-driver/libusb-driver.so ise