release 2.6.35.14

[linux-imx.git] / Documentation / kernel-parameters.txt

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 82d6aeb5228ff62d71a64e04519c24f35a6116e0..713c58944da6a3962ee4c552d7ce16cbecf8f727 100644 (file)
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -254,8 +254,8 @@ and is between 256 and 4096 characters. It is defined in the file
                        control method, with respect to putting devices into
                        low power states, to be enforced (the ACPI 2.0 ordering
                        of _PTS is used by default).
-                       s4_nonvs prevents the kernel from saving/restoring the
-                       ACPI NVS memory during hibernation.
+                       nonvs prevents the kernel from saving/restoring the
+                       ACPI NVS memory during suspend/hibernation and resume.
                        sci_force_enable causes the kernel to set SCI_EN directly
                        on resume from S1/S3 (which is against the ACPI spec,
                        but some broken systems don't work without it).
@@ -917,6 +917,7 @@ and is between 256 and 4096 characters. It is defined in the file
                             controller
        i8042.nopnp     [HW] Don't use ACPIPnP / PnPBIOS to discover KBD/AUX
                             controllers
+       i8042.notimeout [HW] Ignore timeout condition signalled by conroller
        i8042.panicblink=
                        [HW] Frequency with which keyboard LEDs should blink
                             when kernel panics (default is 0.5 sec)
@@ -1265,7 +1266,7 @@ and is between 256 and 4096 characters. It is defined in the file
                        If there are multiple matching configurations changing
                        the same attribute, the last one is used.
 
-       lmb=debug       [KNL] Enable lmb debug messages.
+       memblock=debug  [KNL] Enable memblock debug messages.
 
        load_ramdisk=   [RAM] List of ramdisks to load from floppy
                        See Documentation/blockdev/ramdisk.txt.
@@ -2671,6 +2672,10 @@ and is between 256 and 4096 characters. It is defined in the file
                        disables clocksource verification at runtime.
                        Used to enable high-resolution timer mode on older
                        hardware, and in virtualized environment.
+                       [x86] noirqtime: Do not use TSC to do irq accounting.
+                       Used to run time disable IRQ_TIME_ACCOUNTING on any
+                       platforms where RDTSC is slow and this accounting
+                       can add overhead.
 
        turbografx.map[2|3]=    [HW,JOY]
                        TurboGraFX parallel port interface