* palmas regulator IP block devicetree bindings Required properties: - compatible : Should be from the list ti,twl6035-pmic ti,twl6036-pmic ti,twl6037-pmic ti,tps65913-pmic ti,tps65914-pmic and also the generic series names ti,palmas-pmic - interrupt-parent : The parent interrupt controller which is palmas. - interrupts : The interrupt number and the type which can be looked up here: arch/arm/boot/dts/include/dt-bindings/interrupt-controller/irq.h - interrupts-name: The names of the individual interrupts. Optional properties: - ti,ldo6-vibrator : ldo6 is in vibrator mode Optional nodes: - regulators : Must contain a sub-node per regulator from the list below. Each sub-node should contain the constraints and initialization information for that regulator. See regulator.txt for a description of standard properties for these sub-nodes. Additional custom properties are listed below. For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP, smps45, smps457, smps7 depending on variant, smps6, smps[8-10], ldo[1-9], ldoln, ldousb. Optional sub-node properties: ti,warm-reset - maintain voltage during warm reset(boolean) ti,roof-floor - control voltage selection by pin(boolean) ti,sleep-mode - mode to adopt in pmic sleep 0 - off, 1 - auto, 2 - eco, 3 - forced pwm ti,tstep - slope control 0 - Jump, 1 10mV/us, 2 5mV/us, 3 2.5mV/us ti,smps-range - OTP has the wrong range set for the hardware so override 0 - low range, 1 - high range. Example: #include pmic { compatible = "ti,twl6035-pmic", "ti,palmas-pmic"; interrupt-parent = <&palmas>; interrupts = <14 IRQ_TYPE_NONE>; interrupts-name = "short-irq"; ti,ldo6-vibrator; regulators { smps12_reg : smps12 { regulator-name = "smps12"; regulator-min-microvolt = < 600000>; regulator-max-microvolt = <1500000>; regulator-always-on; regulator-boot-on; ti,warm-reset; ti,roof-floor; ti,mode-sleep = <0>; ti,tstep = <0>; ti,smps-range = <1>; }; ldo1_reg: ldo1 { regulator-name = "ldo1"; regulator-min-microvolt = <2800000>; regulator-max-microvolt = <2800000>; }; }; };